Introduction to the [Setup] Section

1

Summary of the defined workflow settings

Display the main settings of the current workflow profile.

2

[Workflow profile] 

Select a workflow profile or manually define the settings that match your needs.

3

[Language] 

Change the language of the system.

4

[Warning time] 

Define the moment when the system warns you about an action that is required soon, for example 10 minutes in advance. The warning is displayed in the dashboard and indicated through the operator attention light.

5

[Job name truncation] 

Define the way the system shortens the job name when the job name is too long to display fully.

6

[Control panel settings] 

Adjust the brightness and contrast of the screen of the control panel.

7

[Shut down printer] 

Shut down the printer and the controller in a controlled way.

8

[Advanced media settings] 

• Enable or disable the [Pre-printed mode].

• Enable or disable the [Wax mode].

• Set the paper quality factor to [Normal], [Low] or [Lower].

9

[Intermediate check print] 

Print a test sheet of a running job to check the quality.

10

[Detect feeding of multiple sheets by document feeder] 

Enable [Detect feeding of multiple sheets by document feeder] to ensure all originals are scanned.

11

[Accounting] 

Define the [Accounting ID per job] and the [Accounting ID]. The [Accounting ID per job] is only available when the [Accounting ID identification] setting in the Settings Editor on the PRISMAsync controller is set to [Enabled].

12

[System configuration] 

Get direct access to a number of important key operator settings in the Settings Editor on the PRISMAsync controller.