String search
Word search

Vacuum the chiller

Introduction

It is advised to vacuum the chiller every month to keep the printer in the best condition. Vacuuming the chiller is part of periodic maintenance so the operator panel gives a warning when you should vacuum the chiller. Always check the fluid level when you vacuum the chiller.

The procedure is explained in the video Vacuum the chiller, click here to view.

Before you begin

Use Colorado 1630 prescribed:

  • Screwdriver (Torx-25)

  • Vacuum cleaner with a brush head

Procedure

  1. Go to the chiller side and locate the cover under the fan.
  2. Unscrew the left and right screws on top of the cover with the Torx-25.
  3. Lift the cover a little up and towards you (1), then lift it up fully and take it out (2).
  4. Vacuum the condenser surface on the left side of the chiller, as indicated. Make sure you remove all the collected dust.
    CAUTION

    Vacuum the surface with care, make sure you do not damage the condenser surface.

  5. Place the cover back into position.
    IMPORTANT

    Keep the area next to the chiller free. Do not store any items there, as it can result in insufficient cooling and damage to the machine.

  6. Fasten the left and right screws on top of the cover.
  7. When you vacuumed the chiller as part of periodic maintenance, on the operator panel tap on [Completed]  to end the maintenance action.
Parent topic:
Maintain the printer
Privacy Terms of use Cookie information