Loading

Actions for Media-Specific Registration

Procedure

Step

Action

Remark

1

Place the registration sheet with number 1 face down on the glass plate, and touch [OK] to scan.

NOTE

Make sure that the registration sheets are placed correctly in the left-hand upper corner of the glass plate. Make sure that the registration sheet on the glass plate is not curled or has dog ears. You can use a stack of paper to reduce the curl.

You must close the ADF / cover for each scan.

2

Place the registration sheet with number 2 face down on the glass plate, and touch [OK] to scan.

3

Repeat the steps 1 and 2 with the next registration sheets.

4

The media registration is completed when the control panel displays the message [Remove the registration sheet from the glass plate.]

Touch [Next].

5

The control panel displays the message [Do you want to print the verification chart?]. When you touch [Yes], the verification chart is printed.

The automatic media registration is completed.

NOTE

The media specific registration adjustment overwrites any automatic or manual media specific registration performed previously.

6

If the adjustment was successful, this icon appears behind the media registered in the media catalog in the Settings Editor.

7

When the following conditions apply, you must enter the actual sheet size via the manual media registration for this media.

  • The media registration is not optimal and

  • The sheet is larger than 420 mm (16.5") in X direction (feed direction) and larger than 297 mm (11.7") in Z direction (perpendicular to the feed direction).

See Registration Values.

If you do not enter the actual sheet size, you will see a large deviation in front-to-back side registration.

8

Only if the media registration is not optimal, continue with the next option.

Print the verification chart to verify if the media registration is optimal now.