Configure the roll-to-roll mode in Océ Express Webtools

Introduction

When you want to use the take-up unit, your printer has to be in the roll-to-roll mode. When you enable the roll-to-roll mode, the printer will not cut between pages. You can also configure the roll-to-roll mode on the user panel.

NOTE

When the roll-to-roll mode is enabled, each print job is delivered to the [Back output]; even when you set the [Top Delivery Tray] as output location for your prints.
To calibrate the printer the roll-to-roll mode must be disabled.
When the printer is in roll-to-roll mode, you have to cut the media before you can replace a toner cartridge.

Procedure

Open the [Preferences] - [System defaults] tab.
Click on [Edit] in the [Job management] section, or click on the [Roll-to-roll mode] setting.
Select [Enabled] or [Disabled].
Click [Ok] to confirm, or [Cancel] to reject your entries.

Advanced search

Configure the roll-to-roll mode in Océ Express Webtools

Introduction

Procedure