The [修整] tab allows you to specify the finishing settings for the document. Not all settings are available for all finishers.
You can overrule the defined finishing settings in the document, without losing the original finishing settings.
[同文档]
Print the document with the original finishing settings.
[无修整]
Print the document without any finishing settings.
[弯角订书针]
Print the document with 1 staple in the corner, but without any fold and punch settings.
[1 个边沿订书针]
Print the document with 1 staple, but without any fold and punch settings.
[2 个边沿订书针]
Print the document with 2 staples, but without any fold and punch settings.
The paper can be fed into the printer with the long edge or the short edge. This depends how the paper is loaded in the paper tray.
[打印机默认值]
Use paper from the default paper tray of the printer.
[短边]
Use paper from a paper tray where the [进纸边] is [短边].
[长边]
Use paper from a paper tray where the [进纸边] is [长边].
Apply a crease to define a fold line. For example, creasing of the covers is often a part of bookbinding. The well defined folding lines then act as hinges for the folding.
You can select which pages must be creased. The location of the crease is defined in the finishing template used by the finisher.
[无]
[前部]
Only the front edge of the sheet is cut. Use option [修整尺寸] to define the sheet size after trimming. The drop-down list contains predefined sheet sizes, e.g. A4. Or you can select value [自定义] to define the width of the sheet yourself.
[前部、上部、下部]
The front edge and the top and bottom of the sheet are cut. Use option [修整尺寸] to define the sheet size after trimming. The drop-down list contains predefined sheet sizes, e.g. A4. Or you can select value [自定义] to define the width and the height of the sheet yourself. You can also define the [底部偏移].
Enable option [骑马订按压] to apply mechanical pressure to a folded document. The result is a tightly folded document with a flat spine. Use option [调整] to increase or decrease the mechanical pressure.
This setting is not available for all finishers.