The [Обработка] tab allows you to specify the finishing settings for the document. Not all settings are available for all finishers.
You can overrule the defined finishing settings in the document, without losing the original finishing settings.
[Как в документе]
Print the document with the original finishing settings.
[Без обработки]
Print the document without any finishing settings.
[Угловая скрепка]
Print the document with 1 staple in the corner, but without any fold and punch settings.
[1 боковая скрепка]
Print the document with 1 staple, but without any fold and punch settings.
[2 боковые скрепки]
Print the document with 2 staples, but without any fold and punch settings.
The paper can be fed into the printer with the long edge or the short edge. This depends how the paper is loaded in the paper tray.
[Принтер по умолчанию]
Use paper from the default paper tray of the printer.
[Короткий край]
Use paper from a paper tray where the [Край подачи] is [Короткий край].
[Длинный край]
Use paper from a paper tray where the [Край подачи] is [Длинный край].
Apply a crease to define a fold line. For example, creasing of the covers is often a part of bookbinding. The well defined folding lines then act as hinges for the folding.
You can select which pages must be creased. The location of the crease is defined in the finishing template used by the finisher.
[Нет]
[Перед]
Only the front edge of the sheet is cut. Use option [Размер после окончательной обработки] to define the sheet size after trimming. The drop-down list contains predefined sheet sizes, e.g. A4. Or you can select value [Пользовательский] to define the width of the sheet yourself.
[Перед, верх, низ]
The front edge and the top and bottom of the sheet are cut. Use option [Размер после окончательной обработки] to define the sheet size after trimming. The drop-down list contains predefined sheet sizes, e.g. A4. Or you can select value [Пользовательский] to define the width and the height of the sheet yourself. You can also define the [Нижний отступ].
Enable option [Сшивание с прессованием] to apply mechanical pressure to a folded document. The result is a tightly folded document with a flat spine. Use option [Настройка] to increase or decrease the mechanical pressure.
This setting is not available for all finishers.