The [Dokončování] tab allows you to specify the finishing settings for the document. Not all settings are available for all finishers.
You can overrule the defined finishing settings in the document, without losing the original finishing settings.
[Podle dokumentu]
Print the document with the original finishing settings.
[Bez dokončování]
Print the document without any finishing settings.
[Rohová svorka]
Print the document with 1 staple in the corner, but without any fold and punch settings.
[1 Okrajová svorka]
Print the document with 1 staple, but without any fold and punch settings.
[2 Okrajové svorky]
Print the document with 2 staples, but without any fold and punch settings.
The paper can be fed into the printer with the long edge or the short edge. This depends how the paper is loaded in the paper tray.
[Výchozí nastavení tiskárny]
Use paper from the default paper tray of the printer.
[Krátký okraj]
Use paper from a paper tray where the [Okraj vkládání] is [Krátký okraj].
[Dlouhý okraj]
Use paper from a paper tray where the [Okraj vkládání] is [Dlouhý okraj].
Apply a crease to define a fold line. For example, creasing of the covers is often a part of bookbinding. The well defined folding lines then act as hinges for the folding.
You can select which pages must be creased. The location of the crease is defined in the finishing template used by the finisher.
[Žádné]
[Přední]
Only the front edge of the sheet is cut. Use option [Velikost konečné úpravy] to define the sheet size after trimming. The drop-down list contains predefined sheet sizes, e.g. A4. Or you can select value [Vlastní] to define the width of the sheet yourself.
[Přední, horní, dolní]
The front edge and the top and bottom of the sheet are cut. Use option [Velikost konečné úpravy] to define the sheet size after trimming. The drop-down list contains predefined sheet sizes, e.g. A4. Or you can select value [Vlastní] to define the width and the height of the sheet yourself. You can also define the [Posunutí dole].
Enable option [Lis vazby] to apply mechanical pressure to a folded document. The result is a tightly folded document with a flat spine. Use option [Nastavení] to increase or decrease the mechanical pressure.
This setting is not available for all finishers.