This section describes how to load the media into a paper tray.
When you load the media via the [Load] button in the [Schedule], the paper tray is automatically assigned to the correct media.
When you load and assign the media via the [Assign] button in the [Trays] view, you must assign the paper tray to the loaded media manually.
When no external finisher is connected to the machine, you must put all the media types face up and header up into the paper trays. The tabs of tab sheets must be at the right-hand side. When an external finisher is connected to the machine, it is possible that you must put the media into the paper trays in a different way. Refer to the documentation of the external finisher for more information about how to place the media.
The [Schedule] displays a red bar next to a required media. The red bar indicates that a scheduled job now requires a media that is not available in the paper trays.
The [Schedule] displays an orange bar next to a required media. The orange bar indicates that a scheduled job requires media which is either not available in the paper trays or which is available, but not in sufficient quantity to finish the job.
The current job requires more of the same media than is currently loaded in the paper trays. You can add more of the required media into another paper tray.
You already want to load and assign media that are required for the next job (work ahead).
IMPORTANT
Always put the stack of media at the left-hand side of the paper guides inside the paper trays, as indicated on the sticker inside the paper trays.
NOTE
When you want to assign the media later you must press the [Not assigned] button.