Go to the Settings Editor and click . See sections "PCL tray-to-tray mapping" and "PCL tray to media for media <number>" to view the current paper tray mapping. If required, you can change the paper tray mapping in the Settings Editor.
The following table shows the PCL paper tray IDs that are supported by the varioPRINT 6000 series.
Use command <Esc>&l#H to select a paper tray. For example, use command <Esc>&l4H to select paper tray 3.
|
Tray ID PCL5e: <Esc>&l#H PCL6: MediaSource |
Paper tray |
|---|---|
|
1 |
Paper module 1, paper tray 1 |
|
2 |
Paper module 1, paper tray 2 |
|
4 |
Paper module 1, paper tray 3 |
|
8 |
Paper module 1, paper tray 4 |
|
20 |
Paper module 2, paper tray 1 |
|
21 |
Paper module 2, paper tray 2 |
|
22 |
Paper module 2, paper tray 3 |
|
23 |
Paper module 2, paper tray 4 |
|
24 |
Paper module 3, paper tray 1 |
|
25 |
Paper module 3, paper tray 2 |
|
26 |
Paper module 3, paper tray 3 |
|
27 |
Paper module 3, paper tray 4 |
|
99 |
Roll feeder |
Go to the Settings Editor and click . See sections "PCL" to view the default output tray. If required, you can change the default output tray in the Settings Editor.
The following table shows the PCL output tray IDs that are supported to select the output destination.
Use command <Esc>&l#G to select an output tray. For example, use command <Esc>&l1G to select the output tray TOP1_TRAY.
For a <esc>&n#Wp<##> command, # is always the number of characters in ##. For example, TOP1_TRAY uses 9 characters, so the command becomes <esc>@n9Wp<TOP1_TRAY>
|
Tray ID PCL5e: <Esc>&l#G PCL6: MediaDestination |
PJL set outbin=## PCL5e: <esc>&n#Wp<##> |
Output tray |
|---|---|---|
|
0 |
Settings Editor default |
|
|
1 |
TOP1_TRAY | UPPER |
Finisher upper output |
|
2 |
STAPLER_LOWER | LOWER |
Finisher main output |
|
4 |
STACKER1_BULK |
Stacker |
|
5 |
STACKER2_BULK |
Stacker 2 |
|
10 |
STACKER3_BULK |
Stacker 3 |
|
101 |
EXTERNAL |
External finisher |