Correct the color tones with the ACCT function

The automatic correction color tone (ACCT) function corrects slight color deviations in the color tones that can occur over time.

In order to enable the ACCT function in the future, you must first register these color tones as a reference. It is recommended to do the registration right after print system installation. The registration procedure uses an internal sensor to measure the color tones.

To correct slight color deviations in the color tones you can activate the automatic correction color tone (ACCT) function. The ACCT function uses the values of the color tones that are stored during the registration procedure.

This topic describes how to:

• Register the color tones for the ACCT function

• Correct the color tones with the ACCT function

The status and options of the automatic correction color tone function

Register the color tones for the ACCT function

1. Calibrate the printer. (Calibrate the printer)

   IMPORTANT

   You must always perform a printer calibration before you continue with this procedure.

2. Touch [System]  → [Color adjustment]  → [Adjust print engine] .

3. Touch [Auto Correct Color Tone]  → [Register a target condition] .

4. Select the storage place in which you want to store the measured values of the color tones.

5. Press [OK].

6. Select the media.

   IMPORTANT

   Do not stop the registration procedure before it has completed.

7. Press [OK].

8. Follow the instructions on the control panel.

9. Close the menu.

Correct the color tones with the ACCT function

1. Calibrate the printer. (Calibrate the printer)

   IMPORTANT

   You must always perform a printer calibration before you continue with this procedure.

2. Check the print quality to decide if you want to proceed.

3. Touch [System]  → [Color adjustment]  → [Adjust print engine] .

4. Touch [Auto Correct Color Tone]  → [Activate Auto Correct Color Tone] .

5. Select the slot with the values of the previously registered color tones.

6. Press [OK].

7. Select the media.

8. Press [OK].

9. Follow the instructions on the control panel.

10. Close the menu.