Replace the filters (optional)

Introduction

Your printer can be equipped with emission filters. You can replace the filters without service assistance:

The operator panel gives an orange warning when you can replace the filters.
The operator panel gives a red warning when you must replace the filters. The printing process is stopped until you have placed new filters.

Use Océ Colorado 1650 prescribed:

NOTE

For information on the prescribed maintenance materials, see List of Océ Colorado 1650 maintenance materials.

CAUTION

Wear the prescribed gloves when contact with ink or maintenance materials is possible. Gloves should always overlap sleeves. Follow the Safety Data Sheets (SDS) guidelines carefully in order to ensure maximum safety.

On the operator panel tap on the [Tools] icon on the right.
Tap on [Replace the filters] .
Tap on [Replace] and read the instructions..
Put on the Océ Colorado 1650 approved gloves.
Open the top cover from the media input side.
Locate the filters on the left.
Carefully push the printhead carriage to the right away from the filters.
IMPORTANT
Touch the printhead carriage on the covered area only, otherwise you can damage the printheads.
Take the front filter box out by the green handles. Place it on a sturdy surface.
Slide the second filter box to the front and take it out by the green handles. Place it on a sturdy surface.
Take both old filter boxes out of the frames. Dispose the filter boxes according to your local regulations.
Place the new filter boxes in the frames.
Pick up the filter box holder by the green handles. Place the box in the filter compartment with the higher handle on the left. Slide it to the back.
Pick up the second filter box holder by the green handles. Place the box in the filter compartment with the higher handle on the left.
Dispose the gloves as chemical waste according to local regulations.
Close the top cover.
On the operator panel, tap on [Replaced] to end the maintenance action.