Loading

Corrections for Preprinted Media

Introduction

When you use preprinted media, there is a possibility that the image is not at the correct position, even when the media registration is correct. For example, it is possible that a preprinted line along an edge of the media covers part of the printed image. In that case you can perform an image shift for all the jobs that are printed on this media.

Procedure

  1. Print a representative job on the preprinted media.
  2. Measure the distance that the image must shift for the front side and the back side.
  3. In the section [Corrections for preprinted media] enter the values according to the table below.
  4. Click [OK].
  5. Print the job again and check if the image is printed at the correct position.