Connect Publisher Select 3 to imagePROGRAF printers

Introduction

The connect procedure for imagePROGRAF printers can differ from the connect procedure for TDS/PlotWave/ColorWave printers.

NOTE

You can also connect to a imagePROGRAF printer while Publisher Select 3 is open, in a similar way.

Make sure:

The preferred printer is connected to the network and switched on.
The driver for the preferred printer is installed and active.

Check this by printing a test page first.

Start Publisher Select 3.
In the printer area, on the left side of the application, click on [Add printer].
Select a printer from the list or type the [Printer Host Name] or IP address.
Optional: When multiple drivers are installed and match the preferred printer, you can select the preferred driver from a list.

When you start Publisher Select 3 and you have selected a driver in the previous session, you can connect again to the required printer to display the list with available drivers.
Click on [Start] after Publisher Select 3 is connected to one or two printers.