String search

Exact string

Word search

Starts with

Fuzzy match

Symp-Area

Copyright and Trademarks

Introduction

Safety information

Explore the system

Handle the media

Print a job

Maintain the system

Improve quality

Configure the network and security settings

Troubleshooting and support

Regulation Notices

Load a take-up roll core onto the roll winder

Introduction

When you want to wind media, you must load a take-up roll core onto the roll winder first.

IMPORTANT

Make sure you use the core of an empty media roll with the same width or wider as the media you are printing on.

Procedure

Locate the winder on the media output side.
Push the green levers on both sides of the take-up media shaft. Remove the take-up media shaft from the winder.
Pull the handle of the locking mechanism inside the core towards you. Take the empty media roll core and slide it on the media shaft.
Center the core on the media shaft.
Push to place the media shaft back on the winder. Make sure it clicks in place.

What to do next

You can now wind media onto the core, for more information see Print and wind without a tension bar, Print and wind with a tension bar, Print and wind with a locked tension bar.