String search
Word search

Replace the maintenance tray

About this task

When the user panel indicates that the maintenance tray is almost full.

NOTE

When the maintenance tray is completely full, the printer stops printing.

IMPORTANT

By default the [Preferences] - [System defaults] - [Printer properties] - [Go into sleep mode after] setting in Océ Express WebTools is set to 1440 minutes (24 hours). To minimize ink waste it is advised not to change this value.

Before you begin

Procedure

  1. On the user panel tap on [System].
  2. Tap on [Maintenance].
  3. Tap on [Replace the maintenance tray] to start the wizard.
  4. Tap on [Next].
  5. You can now follow the steps in the wizard, or, for more detailed information, follow the steps below.
    NOTE

    From this point you can also follow the video instruction. After that, proceed with step number 13.

    https://vimeo.com/260765713
  6. Unpack the new maintenance tray and remove the disposal bag for the old (full) maintenance tray.
    NOTE

    You can find the folded disposal bag in the opening of the maintenance tray. Make sure the disposal bag is ready for use.

  7. Open the maintenance tray cover.
  8. Put on the gloves and pull the maintenance tray backwards out of the maintenance tray compartment.
  9. Carefully lift the maintenance tray horizontally out of the maintenance tray section.
  10. Wrap the full maintenance tray in the disposal bag and close the zip lock.
    NOTE

    Always keep the maintenance tray in a horizontal position, even when it is wrapped in the disposal bag. Do not carry the maintenance tray in the disposal bag, because the full maintenance tray can damage the disposal bag.

  11. Take off the gloves.
  12. Take the new maintenance tray and push it into the maintenance tray compartment.
  13. Close the maintenance tray cover.
  14. On the user panel tap on [Next] several times, and tap on [Finish] to close the wizard.
Parent topic:
Maintain the print system
Privacy Terms of use Cookie information