Calibrate the printhead carriage

Introduction

When your image is blurred or fuzzy the registration can be off. Calibrate the printhead carriage to align the registration.

First perform the following actions to try and solve your problem, before you calibrate the printhead carriage:

Check if you have filled in the correct [Media thickness ] in the RIP's media settings. For more information, see Change the media settings.
Perform media calibration. For more information, see Calibrate the media.

NOTE

You can only perform printhead carriage calibration when you print without winding. For more information, see Print without winding.
You have to use a typically smooth vinyl media type for the printhead carriage calibration.
You have to use a media width that is larger than 1270 mm.

Load the correct media type. For more information, see Load a media roll (position 1).
On the operator panel tap on the [Tools] icon on the right.
Tap on [Printhead carriage calibration] .
Select the roll you want to use for calibration.
Tap on [Start] .
The printer performs the calibration.

NOTE
The calibration can take quite some time, around 40 minutes. Wait until the printer is finished with the calibration. When the active job disappears and [Start] is no longer greyed out, the calibration is finished.