The PRISMAsync Print Server sends a list of the available output trays to the host. The output trays can be selected using output tray IDs: Media Destination ID. The output tray IDs in the host application are equal to the ID in the IPDS data stream.
The number of available output tray IDs is reported to the host during start-up of the printer. The IPDS output tray ID is directly mapped to the output tray ID of the printer. Output tray ID 0 is not supported.
|
Media Destination ID (decimal) |
varioPRINT 140 Series E1 stacker(s) |
varioPRINT 140 Series F1 stacker (HCS3) |
|---|---|---|
|
1 |
<Settings Editor default> |
<Settings Editor default> |
|
2 |
Stacker top tray |
Stacker top tray |
|
3 |
Stacker/stapler lower tray |
Stacker/stapler lower tray |
|
4 |
Stacker stack tray2 |
Stacker stack tray2 |
|
5 |
Left-hand stacker stack tray2 |
Left-hand stacker stack tray2 |
|
6 |
Stacker/stapler upper tray |
Stacker/stapler upper tray |
|
7 |
Left-hand stacker top tray |
Left-hand stacker top tray |
|
8 |
Stacker/stapler booklet tray |
Stacker/stapler booklet tray |
|
9 |
- |
- |
|
10 |
Stacker stack tray1 |
Stacker stack tray1 |
|
11 |
Left-hand stacker stack tray1 |
Left-hand stacker stack tray1 |
|
241 |
External finisher |
External finisher |
You can map the default output tray in the Settings Editor.
NOTE
Other finishers are not supported in IPDS for this printer.
Offset stacking allows you to separate jobs or documents within the job through an offset of the stacker tray. An Alternate Offset Stacker command in the IPDS data stream will cause the printer to shift the output tray before the next page is stacked.
|
Media Destination ID (decimal) |
varioPRINT 140 Series E1 stacker(s) |
varioPRINT 140 Series F1 stacker (HCS3) |
|---|---|---|
|
1 |
||
|
2 |
+ |
- |
|
3 |
+ |
+ |
|
4 |
+ |
+ |
|
5 |
+ |
+ |
|
6 |
+ |
+ |
|
7 |
+ |
- |
|
8 |
- |
- |
|
9 |
- |
- |
|
10 |
+ |
- |
|
11 |
+ |
- |
|
241 |
- |
- |
The Medium Finishing Control command in the IPDS data stream allows control of stapling. The following commands are supported:
|
Stapling |
Staple(s) position |
varioPRINT 140 Series |
|---|---|---|
|
Corner staple |
Top left |
Option |
|
Bottom left |
Option |
|
|
Edge stitch |
Left edge |
Option |
There is no support for "Control Edge Mark".
The finishing operation commands can only be used when the right media output tray has been selected. For stapling this means output tray number 3.