PRISMAsync sends a list of the available output trays to the host. Output trays can be selected through simple numbers – Media Destination ID. The output tray numbers in the host application are equal to the number in the IPDS data stream.
The number of available logical output bins is reported to the host during start-up of the printer. The IPDS output bin number is directly mapped to the logical output bin number of the printer. Logical bin number 0 is not supported.
|
Media Destination ID (decimal) |
varioPRINT 140 Series E1 stacker(s) |
varioPRINT 140 Series F1 stacker (HCS3) |
|---|---|---|
|
1 |
<Settings Editor default> |
<Settings Editor default> |
|
2 |
Stacker top tray |
Stacker top tray |
|
3 |
Stacker/stapler lower tray |
Stacker/stapler lower tray |
|
4 |
Stacker stack tray2 |
Stacker stack tray2 |
|
5 |
Left-hand stacker stack tray2 |
Left-hand stacker stack tray2 |
|
6 |
Stacker/stapler upper tray |
Stacker/stapler upper tray |
|
7 |
Left-hand stacker top tray |
Left-hand stacker top tray |
|
8 |
Stacker/stapler booklet tray |
Stacker/stapler booklet tray |
|
9 |
- |
- |
|
10 |
Stacker stack tray1 |
Stacker stack tray1 |
|
11 |
Left-hand stacker stack tray1 |
Left-hand stacker stack tray1 |
|
241 |
External finisher |
External finisher |
You can map the default tray in the Settings Editor.
NOTE
Other finishers are not supported in IPDS for this printer.
Offset stacking allows you to separate jobs or documents within the job through an offset of the stacker tray. An Alternate Offset Stacker command in the IPDS data stream will cause the printer to shift the output tray before the next page is stacked.
|
Media Destination ID (decimal) |
varioPRINT 140 Series E1 stacker(s) |
varioPRINT 140 Series F1 stacker (HCS3) |
|---|---|---|
|
1 |
||
|
2 |
+ |
- |
|
3 |
+ |
+ |
|
4 |
+ |
+ |
|
5 |
+ |
+ |
|
6 |
+ |
+ |
|
7 |
+ |
- |
|
8 |
- |
- |
|
9 |
- |
- |
|
10 |
+ |
- |
|
11 |
+ |
- |
|
241 |
- |
- |
The Medium Finishing Control command in the IPDS data stream allows control of stapling. The following commands are supported:
|
Stapling |
Staple(s) position |
varioPRINT 140 Series |
|---|---|---|
|
Corner staple |
Top left |
Option |
|
Bottom left |
Option |
|
|
Edge stitch |
Left edge |
Option |
There is no support for "Control Edge Mark".
The finishing operation commands can only be used when the right media output tray has been selected. For stapling this means output tray number 3.