String search
Word search

Recover Nozzles by Swabbing

Introduction

If a nozzle or group of nozzles do not recover from standard AMS practices, it may be necessary to recover the nozzle by swabbing.

Equipment

  • Foam Tipped Swab (3010118211)

  • Flush (3010106646 Flush UV 1 Litre) or Isopropyl alcohol (99% pure)

NOTE

Tip: To help locate nozzles that need recovering remove the nozzle check print from the vacuum table and place it on the floor under the carriage in the maintenance area. Make sure it is in the correct orientation so the colours are aligned. The print represents a projection of the jetting performance of each printhead. This makes it easier to trace a nozzle or group of nozzle outs back to the area on the actual printhead nozzle plate that requires swabbing.

Procedure

  1. Slide open the maintenance station drawer.
  2. Push the Raise Carriage button.
  3. Dip the foam end of the swab in a small container of flush solution.
  4. Use the lip of the container to wipe away any excess flush from the swab.
    IMPORTANT

    Keep swabs clean prior to use. Do not dip a used swab in the flush solution.

    Do not let the seam on the foam contact the bottom of the printhead. This can damage the printhead. See the next figure.

    Proper Swab Orientation
  5. Position the foam end of the swab at one end of the printhead as shown in the next figure.
  6. Slowly move the swab from one end of the double printhead to the other. Hold the soaked swab against the area of the printhead where nozzles require recovering for 10 seconds.
  7. Rotate the swab by 180 degrees and repeat step 6 for the same printhead.
  8. Use a new dry swab to clean around the openings for the printhead. Run the swab around the perimeter of the opening. See path in figure below.
  9. Use the tip of the swab for the short ends. Turn the swab to the seam side to clean the long ends.

    Take special care to remove ink from the gap between the metal plates of the printhead and carriage base plate. See area indicated by the white ellipses in the figure above.

  10. Repeat the steps for the next printhead that needs recovering nozzles.
    IMPORTANT

    Never use the same swab on two different colour channels.

    Never "scrub" the printhead with a swab as this will drag debris into other nozzles.

  11. Continue until all printheads are cleaned.
  12. Close the Maintenance station drawer.
  13. Do an AMS on the colour channel(s) that were swabbed.

    This is important to clear the flush and any debris from the printhead before a nozzle check is printed.

  14. Print the Nozzle Check Print and evaluate. Repeat swabbing process, if necessary.
Parent topic:
Maintain the Printheads
Privacy Terms of use Cookie information