Introduction
Your printer can be equipped with emission filters. You can replace the filters without service assistance:
-
The operator panel gives an orange warning when you can replace the filters.
-
The operator panel gives a red warning when you must replace the filters. The printing process is stopped until you have placed new filters.
Before you begin
Use Océ Colorado 1640 prescribed:
CAUTION
-
Wear the prescribed Océ Colorado 1640 nitrile gloves.
-
You can wear the Microflex gloves for an hour after they have been contaminated with ink. After an hour you must put on new gloves.
-
You can only wear the Ansell Touch N Tuff gloves for ten minutes after they have been contaminated with ink. After ten minutes you must put on new gloves.
Procedure
-
On the operator panel tap on the [Tools] icon on the right.
-
Tap on [Replace the filter] .
-
Tap on [Replace] and read the instructions..
-
Move to the media input side and wait till the carriage has moved into position.
-
Put on the Océ Colorado 1640 approved nitrile gloves.
-
Open the top cover.
-
Locate the filters on the left.
-
Take the front filter box out by the green handles. Place it on a sturdy surface.
-
Slide the second filter box to the front and take it out by the green handles. Place it on a sturdy surface.
-
Take both old filter boxes out of the frames. Dispose the filter boxes according to your local regulations.
-
Place the new filter boxes in the frames.
-
Pick up the filter box holder by the green handles. Place the box in the filter compartment with the higher handle on the left. Slide it to the back.
-
Pick up the second filter box holder by the green handles. Place the box in the filter compartment with the higher handle on the left.
-
Dispose the gloves as chemical waste according to local regulations.
-
Close the top cover.
-
On the operator panel, tap on [Replaced] to end the maintenance action.
NOTE
