Define finisher adjustments

Note that the finisher adjustments affect all print jobs.

1. Open the Settings Editor and go to: [Preferences]  → [System adjustments] .

2. Go to the [Finisher adjustments] setting.

   Finisher adjustment settings

Adjust the location of the fold in booklets

Use the [Saddle stitch fold placement adjustment] setting to make adjustments to the saddle stitch fold placement.

[Saddle stitch fold placement adjustment] setting

Adjust fold locations

Use the following settings to adjust the fold location:

• [Fold location for tri-fold in];

• [Fold location for Z-folding];

• [Fold location for tri-fold out];

• [Fold location for half-folding];

• [Fold location of front panel for double parallel folding];

• [Fold location of back panel for double parallel folding].

[Fold location for tri-fold in] setting

Enable offset stacking in the stack tray

Use the [Stack tray - Offset stacking] setting to define the offset for the sets in the stack tray. When the value is set to 0, the offset functionality is disabled.

[Stack tray - Offset stacking] setting

Define the minimum filling level of the stackers

Use the [Minimum filling level] setting to define the minimum filling level for the available stackers.

[Minimum filling level] setting

Define the maximum stack height of the stackers

Use the [Maximum stack height] setting to define the maximum stack height of the stackers.

[Maximum stack height] setting

Adjust the trim width of the stacker/stapler trays

Use the [Adjustment of the alignment of the stacker/stapler upper tray] setting to adjust the alignment for the upper tray.

[Adjustment of the alignment of the stacker/stapler upper tray] setting

Use the [Adjustment of the alignment of the stacker/stapler lower tray] setting to adjust the alignment for the lower tray.

[Adjustment of the alignment of the stacker/stapler lower tray] setting

Productivity or sheet alignment for jobs with thin paper

Use the [Priority mode for jobs with thin paper] setting to indicate whether priority must be given to productivity or sheet alignment in the output while printing jobs on thin paper.

[Priority mode for jobs with thin paper] setting

Productivity or sheet alignment for saddle-stitched jobs with few pages

Use the [Priority mode for saddle-stitched jobs with few pages] setting to indicate whether priority must be given to productivity or sheet alignment in the output while printing the saddle-stitched jobs with few pages.

[Priority mode for saddle-stitched jobs with few pages] setting

Productivity or correct staple position for jobs with two staples

Use the [Priority mode for jobs with two staples] setting to indicate whether priority must be given to productivity or sheet alignment in the output while printing the jobs with two staples.

[Priority mode for jobs with two staples] setting

Enable stacker/stapler output tray linking

Use the [Stacker/Stapler output tray linking] setting to indicate whether the lower and upper tray of the stacker/stapler are combined for the delivery of the jobs. It is also possible to combine tray linking with an enlarged upper and lower tray sheet capacity.

[Stacker/Stapler output tray linking] setting

Define the usage of the professional puncher

Use the [Professional puncher usage] setting to define how the puncher must be used.

[Professional puncher usage] setting