SRA IPDS settings

The SRA IPDS settings can be defined in the Settings Editor.

1. Open the Settings Editor.

2. Click tab "Transaction printing".

3. Click "Setups".

4. Select one setup and click "Open".

   NOTE

   You must select only one setup at a time.

5. Click "IPDS setup".

6. Configure the SRA IPDS settings.

   See the table below for detailed information.

SRA IPDS settings

• Quality enhancement

  Enable quality enhancement to enhance the readability of information. Extra pixels are added to characters, lines and images. Images are printed darker. For pages containing images, the rasterisation time will increase if quality enhancement is enabled. When disabled, no extra pixels are added.

• Data resolution

  This setting allows you to specify the resolution of the bitmaps that the printer accepts.

• Font capture

  This setting allows you to specify if fonts can be captured from jobs that are sent to the printer for later reference. This setting also controls whether captured or installed fonts are selectable.

• Extend logical page

  The logical page size is virtually extended with the entered number of millipoints. This makes it possible to print (slightly) larger page sizes to prevent that information cannot be printed on a page.

• Output recovery

  When output recovery is suppressed, the printer does not check if the output is correct after a recovery. The host system and the operator are responsible for the recovery. This means that the operator must indicate at the host where printing needs to resume.

• Face orientation

  With this setting, the default face orientation of the requested finisher can be overruled per setup.

NOTE

Mpt = millipoints = 1/72000 inch.

• The image shift in feed direction is the margin of the front edge and the back edge of the sheet. The front edge and back edge are defined by the feed direction of the sheet. The image shift in cross-feed direction is the margin of the side edges of the sheet. Side 1 is the front of a sheet. Side 2 is the back of a sheet.

IPDS tray-to-tray mapping
Logical tray for <tray name> NOTE For all supported physical input trays of the product type. Default values are specified in the tray-to-tray section.	1 – 16 NOTE Each logical tray must have a unique value.

IPDS tray to media for tray x
Media attributes	From media catalogue NOTE Each media attribute must be unique.
Feed direction for media	SEF, LEF (default)