Creasing of the first and last sheets of subsets

Syntax

XPath: //CreasingParams/Crease/GeneralID[@IDUsage="oce:CreaseCondition"]@IDValue

Type

NMTOKEN

Supported range

Remark

The tool can apply a crease only parallel to the leading/trailing edge over the full width and only at the half fold position.

There is no support for the creasing orientation, therefore two orientations are accepted.

There is no support for direct control of the WorkingDirection [Top, Bottom]. Both will be the result of other finishing settings that control facing or feed direction.

Example

<JDF Type="Combined" Types="... Creasing ...">

<ResourcePool>

<CreasingParams ID="res_1" Class="Parameter" Status="Available">

<GeneralID IDUsage="oce:CreasePattern" IDValue="FoldCatalog"/>

<GeneralID IDUsage="oce:FoldCatalog" IDValue="F4-1"/>

<GeneralID IDUsage="oce:CreaseCondition" IDValue="FirstOfSubset"/>

</CreasingParams>

</ResourcePool>

<ResourceLinkPool>

<CreasingParamsLink rRef="res_1" Usage="Input"/>

</ResourceLinkPool>

</JDF>